HP Media Center m270 Desktop PC - Manual (Page 66)

58
Removing Add-In Cards
1
Disconnect any external and internal cables attached
to the card.
2
Loosen the screw on the bracket of the card you are
replacing.
3
Hold the metal bracket and the far top corner of the
card. Carefully remove the card by pulling the card
straight out of the expansion slot.
Replacing Add-In Cards
1
Insert the new card into the slot and push straight
down. Make sure the card is properly seated.
2
Attach the screw to secure the card you have
replaced.
3
Connect any internal cables to the card.
w
Be careful of the
sharp edges on
the expansion
slot cover.
w
Do not overload
the PC by
installing add-in
cards that draw
excessive current.
The chassis is
designed to
provide 2 amps
(average) of +5 V
power for each
board or card in
the chassis. The
total +5 V current
draw in a fully
loaded chassis
(one with all
add-in card slots
filled) must not
exceed the total
number of slots
multiplied by
2 amps.