HP NonStop G-Series User Manual
Page 21
Caution
If you include the RQADDR parameter, do not specify "JSL" as its value.
Enter the following parameters:
To identify the SRVGRP parameter, type the previously defined group name value from the *GROUPS
section.
1.
To indicate the SRVID, type a number between 1 and 30,000 that identifies the server within its group.
2.
Verify that the syntax for the CLOPT parameter is as follows:
CLOPT= "-- -n 0x0002PPPPNNNNNNNN -d /dev/tcp -m2 -M4 -x10"
Note
The CLOPT parameters may vary. Refer to
for pertinent command-line information.
3.
If necessary, type the optional parameters:
Type the SEQUENCE parameter to determine the order that the servers are booted.
●
Specify Y to permit release of the RESTART parameter.
●
Type 0 to permit an infinite number of server restarts using the GRACE parameter.
●
4.
Table 3-1. Command Line Options for JSL
Command Line Option
Description