HP MPX200 Multifunction Router - Manual (Page 137)

Syntax
target
Keywords
rescan
Examples
The following example shows the target rescan command:
mpx200 (admin) #> target rescan
nl Scanning Target WWPN 00:00:02:00:00:00:00:00
nl Target Rescan done
nl Scanning Target WWPN 00:00:03:00:00:00:00:00
nl Target Rescan done
nl
Scanning Target WWPN 00:00:01:00:00:00:00:00
nl Target Rescan done
nl
Scanning Target WWPN 50:08:05:f3:00:1a:15:11
nl Target Rescan done
nl Scanning Target WWPN 50:08:05:f3:00:1a:15:19
nl Target Rescan done
nl Target Re-Scan completed
To rescan targets in the CLI:
1.
Open a miguser session using the following command:
miguser start -p config
2. To rescan for target ports, enter the following command:
target rescan
For example:
mpx200 (admin) #> target rescan
nl Scanning Target WWPN 00:00:02:00:00:00:00:00
nl Target Rescan done
nl Scanning Target WWPN 00:00:01:00:00:00:00:00
nl Target Rescan done
nl Scanning Target WWPN 00:00:03:00:00:00:00:00
nl
Target Rescan done
nl Scanning Target WWPN 50:08:05:f3:00:1a:15:11
nl
Target Rescan done
nl Scanning Target WWPN 50:08:05:f3:00:1a:15:19
nl Target Rescan done
nl Target Re-Scan completed
targetmap
Presents or removes existing presentation of discovered FC and iSCSI targets on FC, iSCSI, and
FC over Ethernet (FCoE) ports.
Authority
admin
Syntax
targetmap
Commands 137