HP ProLiant SL230s Gen8 Server - Manual (Page 38)

Hardware options installation 38
7. Install the server into the chassis (" Installing the server into the chassis " on page 25 ).
8. Power up the server (on page 15 ).
After installing the DIMMs, to configure memory protection mode, use RBSU (" HP ROM-Based Setup Utility "
on page 83 ).
Drive guidelines
When adding drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one drive is used, install it in the bay with the lowest device number.
• To provide the greatest storage space efficiency when drives are grouped together into the same drive
array, drives must be the same capacity.
Installing a hot-plug drive
1. Remove the drive blank.
2. Prepare the drive.