HP Smart Array P600-Controller - Manual (Page 8)

Overview of the installation procedure 8
7. Disconnect peripheral devices.
8. Install the controller hardware (" Installing the controller hardware " on page 9 ).
9. Connect storage devices to the controller (" Connecting external storage " on page 11 , " Connecting
storage devices " on page 10 ).
10. Reconnect peripheral devices and the AC power supply to the server.
11. Power up peripheral devices.
12. Power up the server.
13. Update the controller firmware (" Methods for updating the firmware " on page 12 ).
14. (Optional) Set this controller as the boot controller using ORCA (" Setting a controller as the boot
controller " on page 14 ).
15. (Optional) Change the controller boot order using RBSU (" Setting the controller order " on page 14 ).
16. If the controller will not be the boot device, install the device drivers (" Installing device drivers " on
page 16 ).
17. If new versions of the Management Agents are available, update the Management Agents
("
Installing Management Agents " on page 16 ).
18. (Optional) Create additional logical drives (" Configuring an array " on page 13 ).
The server is now ready to use.