HP Digital Sender Flow 8500 fn1 Document Capture Workstation series - Manual (Page 80)

c. Scroll down through the online maintenance procedure and touch the Complete Maintenance
Procedure button.
d. Touch OK to record the maintenance activity and reset the counters to zero.
NOTE: HP recommends that you replace the rollers and separation pad every 100,000 scans.
Replace the front panel
TIP: An animation which guides you through removing and replacing the front panel is available on
the web (see www.hp.com/support , and search on your product).
To replace the front panel, follow these steps:
1. Press the Power button to turn off the product, and then disconnect the power cable.
2. Raise the scan lid.
3. Locate the indents on the underside of the front panel, press in at the location shown, and then lift
the front panel gently as it releases.
4. Invert the front panel, hold it firmly with one hand, disconnect the ribbon cable (1), and then
gently pull the ribbon cable through the cable restraint (2).
72 Chapter 8 Replace and install components ENWW