HP 9250c Digital-Sender - Manual (Page 82)

Table 4-5 Addressing Settings
Callout Area on the screen Information or capability that the area provides
1 HP EWS tabs and menus For more information, see Navigating through the HP Embedded Web
Server .
2 Help Click to open a help file that contains information about the screens on the
Digital Sending tab.
3 Allow Device to directly access
an LDAP Address Book Select this check box to provide the device direct access to an LDAP Address
Book.
4 LDAP Server Bind Method Anonymous Select this option to connect to the LDAP
server if the LDAP server does not
require user credentials to access the
LDAP database.
Simple Select this option to connect to the LDAP
server if the LDAP server requires user
credentials to use the LDAP database.
When this option is selected, you must
enter the user, password, and domain.
Note that the password will be sent
across the network unencrypted.
Simple over SSL Select this option to connect to the LDAP
server if the LDAP server requires user
credentials to use the LDAP database.
This option supports Kerberos v2.
When this option is selected, you must
enter the user, password, and domain.
NOTE This option is not
available for all products.
Kerberos The selected LDAP (Active Directory)
Server requires user credentials. A
Kerberos ticket will be obtained from the
Kerberos (Active Directory) Server and
used to authenticate to the LDAP Server.
The Password will be sent across the
network encrypted and will be
unreadable to a third party.
In order to use Kerberos as a bind
method, you must first configure
Kerberos settings. If using "user's
credentials", make sure that Kerberos
Authentication is required for e-mail.
5 Use Device User's Credentials You can only use this setting if Authentication is enabled for SMTP and
individual device users have accounts on the SMTP server. In most
cases, Use Public Credentials is the preferred method.
6 Use Public Credentials Use this setting to set a single name and password for SMTP authentication
for the device to use for all users.
These public credentials are used to connect to the LDAP directly. When
public credentials are entered, these credentials are used by the device to
access the LDAP directory when any user uses the device.
7 Bind Prefix The Bind Prefix setting is the LDAP attribute used to construct the user's
Distinguished Name (DN) for authentication. This prefix is combined with the
72 Chapter 4 Setting the digital sending options ENWW
Digital Send
in
g