HP 3PAR System Reporter Software - Manual (Page 77)

“Low Bucket” (page 85)
“High Bucket” (page 85)
“Sum End Buckets” (page 85)
Standard Report Types
The following standard report types are available ( Table 10 (page 77) ):
Table 10 Standard Report Types
Purpose Report Type
Display metric versus time. The beginning of the time range is specified by the Begin/At
Time control (see
“Begin/At Time” (page 85) ) and the end of the time range is specified
by the End Time control (see “End Time” (page 86) ).
Versus Time
Unless the Compare control is available and set to something other than none, the
Versus Time report shows aggregate metric for all the selected objects over a range
of time. See
Figure 28 (page 78) for an example.
If the Compare control (see “Compare” (page 82) ) is set to a specific object, then the
Versus Time report plots the metric separately for each of up to 16 of the objects so
that they can be compared.
Figure 29 (page 79) shows an example where the
performance of systems is being compared.
Display metric at the time specified by the Begin/At Time control (see “Begin/At Time”
(page 85) ). For this type of report, the Group By (see “Group By” (page 83) ) and
At Time
Order By (see “Order By” (page 84) ) controls are enabled and can be used to compare
different groupings of object type. “Group By System:Host At Time Report Example”
(page 80) shows an example of an example with System and Host selected in the
Group By control and IOPs/s selected in the Order By control.
Display service time histogram versus time, with a separate data series for each service
time bucket between the Low Bucket (see
“Low Bucket” (page 85) ) and the High Bucket
(see “High Bucket” (page 85) ).
Histogram Versus Time
The beginning of the time range is specified by the Begin/At Time control (see
“Begin/At Time” (page 85) ) and the end of the time range is specified by theEnd Time
control (see “End Time” (page 86) ). See “Histogram Versus Time Report Example”
(page 81) .
Display histogram of metric at the time specified by the Begin/At Time control (see
“Begin/At Time” (page 85) ). This control is available only for PD, LD, Port and VLUN
performance reports. See “Histogram At Time Report Example” (page 82) .
Histogram At Time
For each report type, controls in the report menu that do not apply to that report type are disabled.
NOTE: For complete details on Adaptive Optimization reports, see “Adaptive Optimization
Reports” (page 113) .
Creating Custom Reports 77