HP XP P9500 Storage - Manual (Page 381)

Audit Log Category : -
Audit Log Facility : -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
Example 7
The following example shows how to display the number of times the
same path can be used for load balancing:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -lbpathusetimes
Times Same Path Was Used : 1
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
Example 8
The following example shows how to display the number of times the
same path can be used for extended load balancing:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -expathusetimes
Times Same ExPath Was Used : 100
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
To display path information
When displaying path information, if you specify either the -item or -c
parameter and also specify the -path parameter, you can select the items to
display and display a summary of path information. This section describes
each parameter and the displayed path information.
To display path information
-path
When you specify the -path parameter and do not specify either the -c or
-item parameter, the command displays information about the paths
managed by HDLM without abbreviating or selecting items.
In the sub-parameters (following -path), you can filter the paths to be
listed using -hdev and sort the list using -srt. When you omit both
parameters, the command displays information for all the paths in order
of increasing AutoPATH_IDs.
For details on what is displayed in each item, see
Table 6-12 Displayed
Path Information on page 6-47 .
AutoPATH_IDs displayed by the -path parameter depend on the sequence
in which HDLM detects the paths after a host is started up. Because of
this, make sure that you use the path name PathName to identify a path.
The following shows the subsequent sub-parameters (following -path):
-hdev host-device-name
Command Reference
6-41
Hitachi Dynamic Link Manager User Guide for Solaris ®