HP XP Continuous Access Software - Manual (Page 162)

162 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
pairmon
Report pair transition status
Description
The pairmon command is sent to the RM (daemon) to report the transition
of pairing status. When an error or status transition is detected, this
command outputs an error message.
Events exist on the pair state transfer queue for RM. Resetting an event
correlates to the deletion of one or all events from the pair state transfer
queue. If the command does not reset, the pair state transfer queue is
maintained.
The table below shows the results of pairmon argument combinations.
–D –nowait –resevt –allsnd Actions
–D When RM does not have an event, this option waits until an
event occurs. If more events exist, it reports one event.
This option clears the event that it reports.
Invalid –allsnd When RM does not have an event, this option waits until an
event occurs. If more than one event exists, it reports all
events without clearing them.
Invalid –resevt When RM does not have an event, this option waits until an
event occurs. If multiple events exist, it reports one event
and resets (clears) all events.
Invalid –resevt –allsnd When RM does not have an event, this option waits until an
event occurs. If multiple events exist, it reports all events
and then clears them.
Invalid –nowait When RM does not have an event, this option reports “no
event” immediately. If multiple events exist, it reports one
event.
This option resets (clears) the event which it reported.
Invalid –nowait –allsnd When RM does not have an event, this option reports “no
event” immediately. If more events exist, then it reports all
events.