HP XP Continuous Access Software - Manual (Page 273)

Troubleshooting RAID Manager 273
Command errors
Command Error Problem Action
EX_ATTDBG This command failed to communicate
with RM, or a log directory file could
not be created. Verify that RM is functioning properly.
EX_ATTHOR Connection could not be made with
RM. Verify that RM has started and that the
correct HORCMINST value has been
defined.
EX_CMDIOE The request to the command device
either failed or was rejected. Check to see whether the syslog file of
the host reports an Illegal Request (0x05)
Sense Key, if so, then verify:
• The BC/CA functions are installed on
the disk array;
• The ESCON RCP and LCP ports are
set properly;
• The CU paths have been established;
• The target volume is available.
EX_CMDRJE The request to the command device
either failed or was rejected. Verify the following:
• The BC/CA functions are installed on
the disk array.
• The ESCON RCP and LCP ports are
set properly.
• The CU paths have been established.
• The target volume is available.
EX_COMERR This command failed to communicate
with RM. Verify that RM is running.
EX_ENAMLG Undefined error. Call the HP support center.
(continued)