HP XP P9500 Storage - Manual (Page 316)

Use the dlnkmgr command's view operation:
Execute the following command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
KAPL01001-I The HDLM command completed normally. operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
When the HDLM Manager column shows Alive, the HDLM manager is
active.
Use a script for confirmation:
Execute the following command to confirm that the HDLM manager is
active:
# /etc/init.d/DLMManager status
dlmmgr (pid 14889 14886 14884 14880) is running...
Note
If an error occurs, the execution results of the dlnkmgr command's view
operation might be different from those of the DLMManager status
command. In this case, see the execution results of the dlnkmgr
command.
Stopping the HDLM Manager
To stop the HDLM manager, log in to Linux as a user with root permissions,
and then execute the following command:
# /etc/init.d/DLMManager stop
Stopping DLMManager: [ OK ]
Lower case characters can be used for the command name (dlmmanager).
# /etc/init.d/dlmmanager stop
Stopping DLMManager: [ OK ]
The stop script that was set up during HDLM installation runs, and stops the
HDLM manager.
Use one of the following procedures to confirm that the HDLM manager has
stopped:
Use the dlnkmgr command's view operation:
Execute the following command.
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver WakeupTime
Dead
KAPL01001-I The HDLM command completed normally. operation name
4-20
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Linux(R))