HP ProLiant WS460c G6 Workstation-Blade - Manual (Page 19)

Operations 19
3. If you are removing the graphics card from the PCIe card cage, disconnect the power cables from the
graphics board.
4. Remove the two Torx-15 screws that secure the front of the PCIe card cage (1).
5. Carefully pull up on the front and right sides of the PCIe card cage to disengage it from the anchoring
pins on the expansion blade enclosure, and then lift the PCIe card cage out of the expansion blade
enclosure (2).
Configure the WS460c Graphics Expansion Blade
configuration with HBA
NOTE: This unique configuration is for users who want to use a single mezzanine card with the
graphics expansion blade. (For example, using a HBA to connect to storage.) This configuration
permits the use of only one PCIe slot on the graphics expansion blade.