HP OneView for VMware vCenter - Manual (Page 75)

◦ HP XP P9000/HP XP—Not applicable
◦ HP StoreOnce Backup—Not applicable
•
Active Path—Specifies whether the path is active or in standby status
If a path is active and then goes offline, a standby path takes over.
•
Path ID—Path ID assigned by VMware
•
VMware Disk Identifier—Disk name assigned by VMware
Viewing replications
The replications page displays the following information:
•
Source Disk Name—Source replication disk
•
Source Array—Array identifier for the local (source) array; displayed only for Continuous
Access replications and not supported for HP MSA arrays
•
Replication Type—The type of replication used:
HP StoreVirtual—Snapshot, Remote Snapshot ◦
◦ HP 3PAR StoreServ—Virtual copy, Physical copy, Peer Persistence
◦ HP EVA—Snapshot, Snapclone, Mirrorclone, Continuous Access
◦ HP MSA—Not applicable
◦ HP XP P9000/HP XP—P9000 or XP Business Copy, P9000 or XP Snapshot, P9000 or
XP Continuous Access
◦ HP StoreOnce Backup—Not applicable
•
Replica Name—Target replication disk
•
Replica Array—Array identifier for the remote (target) array; displayed only for Continuous
Access replications and not supported for HP MSA arrays
•
Replica Status—Status of the replica (for example, PAIR, SUSPEND, SYNCHED, or COPY)
•
Replication Group
HP StoreVirtual—Not applicable ◦
◦ HP 3PAR StoreServ—Remote Copy group name
◦ HP XP P9000/HP XP—Replica group ID
◦ HP EVA—Data replication group name
◦ HP StoreOnce Backup—Not applicable
•
Datastore/RDM Type—Datastore/RDM type (Datastore or RDM)
•
Datastore Name—Datastore name
•
Source Creation Time—Source volume creation time (applies only to HP 3PAR StoreServ)
•
Source Expiration Time—Source volume expiration time (applies only to HP 3PAR StoreServ)
•
Source Retention Time—Source volume retention time (applies only to HP 3PAR StoreServ)
Using the StoreFront Module for vCenter 75