HP ProLiant DL320s Server User Manual
Page 37
Advertising
Hardware options installation 37
7.
Remove the cache module from the controller.
8.
Install the new cache on the controller. Press firmly above each connector to ensure good electrical
contact. If the cache is not properly connected, the controller will not boot.
9.
Replace the controller in the server. The controller is installed in expansion slot 2.
10.
Replace the upper tray.
11.
Install the battery pack into the server.
12.
Route the cable, and connect it to the cache module.
CAUTION:
When routing cables, always be sure that the cables are not in a position where
they can be pinched or crimped.
Advertising