HP Surestore NAS - Manual (Page 18)

2-6 Basic Installation
5. If required, use the four screws supplied to fix the CD-ROM
server in place. Use the upper or lower holes depending on the
type of tower and its mounting requirements. See the figure
below.
CAUTION ❏ The length of the screws must not exceed 0.2 inch (5 mm). If
they do, the internal components of the CD-ROM server
may be damaged.
6. Attach the power cable to the CD-ROM server. The power
connector on the CD-ROM server is a standard PC 4-pin power
connector (12 and 5 Vdc), as shown in the picture below.
7. Connect the external network connector board to the CD-ROM
server using the ribbon cable. The network connector board
includes network connectors and the Reset button.
The board is intended to be mounted on the back of the
CD-ROM tower. The mounting plate on the board fits into
standard parallel-connector cut-out holes available on most
towers.
Power supply connector
hp.book Page 6 Thursday, April 2, 1998 4:33 PM