HP Netserver L Server series - Manual (Page 112)

Chapter 12 Troubleshooting
106
Figure 12-3. Battery on System Board
7. Insert the new battery with the positive sign (+) facing up. Push the battery
down into the socket.
The battery should snap into place. Ensure the spring latch holds the
battery firmly.
8. Replace the PCI card cage, processor cooling fan, and cover.
9. Power on the Netserver.
10. Press <F2> to run the Setup Utility and reset the CMOS settings. Refer to
“Setup (BIOS) Utility” in Chapter 10, "Configuring the HP Netserver."
Problems Running the Setup Utility
If you cannot run the Setup Utility, the HP Netserver's configuration in CMOS
memory may have become corrupt. The only way to recover from a corrupted
configuration is to clear it. Refer to "Clearing the CMOS Configuration," earlier in
this chapter.