HP Insight Management Agents - Manual (Page 100)

— noDigest
— crc32c
• Data Integrity displays the iSCSI data digest scheme in use within this connection. The
following values are valid:
— none
— other
— noDigest
— crc32c
Sub-system Classification
Power Subsystem
This section displays information about the redundant power supplies. The following entries
may be displayed:
• Location—Displays the bay where the power supply is located.
• Condition—Displays the status of the power supply. The following values are possible:
— OK—A power supply is installed and operating normally.
— Failed—A power supply is installed and is no longer operating. Replace the power
supply.
— Not Installed—Nothing is installed in this power supply bay.
— Unknown—The Server Agent is unable to determine if this storage system power supply
bay is occupied.
• Serial Number—Displays the serial number of the power supply. This information can be
used for identification purposes.
• Firmware Revision—Displays the firmware revision of the power supply.
• Present—Represents whether the power supply is present in the chassis.
• Status—Represents the status of the power supply in the chassis. The following values are
possible:
— No Error
— General Failure
— Bist Failure
— Fan Failure
— Temperature Failure
— Interlock Open
— EPROM Failed
— VREF Failed
— DAC Failed
— RAM Test Failed
— Voltage Channel Failed
— Orring Diode Failed
— Brownout
— Give Up On Startup
— NVRAM Invalid
— Calibration Table Invalid
— If the power supply is absent, the status is "Not Applicable"
• Used Capacity (%)—Represents the current power supply capacity which is a percentage
of its maximum capacity.
• Used Capacity (W)—Represents the current power supply capacity in watts.
100 Agent information