HP Insight Management Agents - Manual (Page 116)

Modem", "External Port", "External Modem", "External Direct Connect," or "External XonXoff".
The tables may contain the following:
•
Model—Displays the model of the communication device.
•
Data Settings—This table contains the data settings for the communication device including:
Alarms—Displays if the Remote Insight firmware uses this communication device to deliver
traps. ◦
◦ Non-PPP—Displays if non-PPP connections are allowed on this port.
◦ Baud Rate—Displays the baud rate to be used on this port.
◦ Data Bits—Displays the number of data bits to be used on this port.
◦ Stop Bits—Displays the number of stop bits to be used on this port.
◦ Parity—Displays the type of parity to be used on this port.
◦ Pager Settings—Displays pager settings for the communication device.
◦ Alarms—Displays if the Remote Insight Board firmware uses this port to deliver pages.
◦ Message—Displays the message that appears in the body of the page.
◦ Baud Rate—Displays the baud rate to use for pager messages.
◦ Data Bits—Displays the number of data bits to user for pager messages.
◦ Stop Bits—Displays the number of stop bits to use for pager messages.
◦ Parity—Displays the type of parity to user for pager messages.
•
Modem Control Strings—This table contains the modem control strings for the communication
device including the following:
◦ Reset—Displays the string used to reset the modem.
◦ Initialize—Displays the string used to initialize the modem.
◦ Dial Prefix —Displays the string pre-pended to phone numbers before dialing.
Self Test Results
The Self Test Results section indicates various error-status depending on the Remote Insight model.
The following is the list of error-status fields:
•
Busmaster I/O Reads
•
Memory
•
Internal Modem Firmware
•
Internal Modem
•
External Port
•
Keyboard Interface
•
Battery Interface
•
NVRAM Interface
•
NVRAM Write/Read/Verify
•
Video SideCard
•
PCMCIA
•
NIC
•
Mouse
•
CPLD
116 Agent information