Airlink PinPoint EDGE/GPRS - Manual (Page 117)

PinPoint EDGE/GPRS - User Guide, version 2.32 111
AT Commands: PinPoint
*PPTAIPID=nnnn
*PPTIME=n
*PPTSV=n
*UDPRGPS=n
GPSn
GPS reports will be retransmitted if not acknowledged by the server.
Sets/queries the TAIP ID. This ID is returned in TAIP reports if it has been negotiated with the
TAIP client. This value is only used in conjunction with TAIP emulation mode
(*PPGPSR=F0).
nnnn=TAIP ID (4 characters)
GPS Report Time Interval See also *PPMINTIME, *PPTSV
n=seconds (1 - 65535)
Caution: A report time of less than 30 seconds can possibly keep an RF link up
continuously. This will eventually cause the PinPoint to overheat and shutdown.
An RF resource may continue be tied up to transfer small amounts of data. Gener-
ally the RF channel will be released and go dormant in 10-20 seconds of no data
sent or received.
Note: Your Wireless Service Provider may impose a minimum transmit time.
Timer for Stationary Vehicles. Time interval in minutes that the PinPoint will send in reports
when it is stationary.
n=1-255 minutes
n=0 : Disabled
For example, if *PPTIME=10, the PinPoint will send in reports at least every 10 seconds
while it is moving; however, once it stops moving, it will slow the reports down to this
*PPTSV value.
Set or query GPS stamping of UDP Reliable packets. When set, data received on the host
serial port will be encapsulated with the GPS date and time.
n=0 : Disabled (default)
n=1 : Enabled
PinPoint related AT Commands not Available through Wireless Ace
Send NMEA GPS strings out serial link. See also *PGPS.
ATGPS (no parameter) will cause the NMEA GGA, RMC, and VTG GPS strings to output to
the serial port one time.