GE PSB9240SFSS - Manual (Page 4)

Design Information
4
PRODUCT DIMENSIONS AND CLEARANCES
NOTE: Appearance will vary by model.
TOOLS AND PARTS REQUIRED
(NOT SUPPLIED )
‡ #2 Phillips screwdriver
‡ Hand held drill
‡ High speed drill bit, 3/32" diameter
‡ 3/8" slot head screwdriver
‡ Level
‡ Saw
‡ 2x4 or 2x2 lumber for installing runners
or 3/8" plywood for floor (if required)
‡ Wood screws or other hardware for installing
runner or shelf to support oven (if required)
‡ Safety glasses or goggles
PARTS SUPPLIED
‡ 6 brass screws (3 required, 3 extra)
‡ 5 color matched screws (4 required, 1 extra)
‡ Bottom trim
ELECTRICAL TOOLS AND PARTS
REQUIRED (NOT SUPPLIED)
‡ Junction box
‡ Electrical cable (3-conductor or 4-conductor wire as
required by local codes)
‡ UL-listed conduit connectors
‡ Wire cutters and wire strippers
ADVANCE PLANNING
‡ These ovens may be installed directly into a 30” wide
oven cabinet.
‡ Cutout dimensions are NOT the same for installation
with or without an accessory storage drawer. Make
sure to use the correct cutout when preparing the
opening.
NOTE: Model ZSC2202 CANNOT be installed with
an accessory storage drawer. See Installation
Preparation Without an Accessory Storage Drawer
for this model.
IMPORTANT
³
This oven is not approved for
use above another built-in Advantium Speedcook
oven, a side by side installation or below a
countertop.
‡ For personal safety, this oven cannot be installed
in a cabinet arrangement such as an island or
peninsula.
‡7KHRYHQPXVWEHLQVWDOOHGDWOHDVWµDERYH
the floor.
‡$OORZIRUFOHDUDQFHWRDGMDFHQWFRUQHUVZDOOV
drawers, etc.
‡&DELQHWVLQVWDOOHGDGMDFHQWWRZDOORYHQV
must have an adhesion spec of at least 194ºF
temperature rating.
The oven must be securely installed in a cabinet
that is firmly attached to the house structure.
Weight on the oven door could cause the oven
to tip and result in injury. Never allow anyone to
climb, sit, stand or hang on the oven door.
If installing the drawer accessory, the drawer must
be assembled to the oven prior to installation into
the cabinet. See the Accessory Storage Drawer
Assembly Instructions.
21-1/2”
1”
13”
19”
29-3/4”
1-1/10s
1-3/5s