GE JP328CKCC - Manual

Dimensions and Installation Information
JP328WK/CK/BK
GE ® 30" Built-In Electric Cooktop
For answers to your Monogram, ® or GE ® appliance
questions, visit our website at ge.com or call GE
Answer Center
® service, 800.626.2000. Specification Revised 3/14 321346
Listed by
Underwriters
Laboratories
Electrical junction box 16" MIN.
below countertop
30" MIN. to
unprotected
cabinet
Cut should
not interfere
with cabinet
structure
at front
5-1/2"
clearance to
side wall
from cut-out
2"
clearance to
side wall
from cut-out
18" MIN.
to cabinet
1-3/4" to
rear wall
13" MAX.
depth
† Note: Check local codes for required breaker size
Important: Maintain 5" (12.7 cm) minimum
vertical clearance between the cooktop bottom and any
combustible surfaces. Clearance not required when installing
wall oven underneath. Requires an 18" minimum from cooktop
to adjacent overhead cabinets.
Units are furnished with a 48" flexible armored cable.
Cooktop models JP328WK/328BK/328CK/328SK are approved
for use over GE 27" or 30" Single Wall Ovens. Refer to cooktop
and wall oven installation instructions packed with product
for current dimensional data.
If installed with a
GE Telescopic Downdraft System, consult
both cooktop and downdraft installation instructions packed
with product before installing. Cooktop gas/electric supply
may need to be re-routed to install downdraft.
The countertop must be at least 26" deep with a flat surface
area of 23-1/2" or more, front to back. In addition, other
clearances to the front edge of the countertop must be
considered.
This cooktop
cannot be installed in countertops that cannot
accept screws, such as granite or marble, etc.
Filler Trim Kit: When replacing an old GE 30" cooktop (with
larger opening) use the following one-piece trim kit to fill in the
over-size hole. Available at additional cost. JXTR31W (White)
JXTR31C (Bisque) JXTR31B (Black)
KW Rating
240V 7.4
208V 5.6
Breaker Size
240V 40 Amps †
208V 30 Amps †
Cooktop
2-1/2"
(min.)
28-1/2"
19-1/2"
30-1/4"
21-1/4"
3