GE JV394SBB - Manual (Page 5)

2. Attach the damper/duct connector.
Use two (2) screws (provided) to attach the connector
to the housing. The damper flap should open in the
direction indicated by the arrow.
3. Remove the electrical knockout.
Choose either the top or side of the housing for the
electrical cable entrance. Remove the appropriate
knockout.
4. Set the housing into the opening.
Carefully lower the housing into the cabinet opening
with the slide control to the front.
5. Remove the access cover.
6. Open the filter panel.
Pull the visor slides out. Rotate the panel clips and
swing the panel open.
5
INSTALLATION INSTRUCTIONS
FRONT
OF HOOD
7. Install the mounting brackets.
Insert the bent end of the installation rod into the
access hole in the housing.
Choose the mounting bracket with the center hole.
Hang the bracket from the rod, through this center hole,
as shown. Pull the bracket up between the cabinet and
housing.
Hold the mounting bracket in place with the rod. Two
sets of screws are provided. Use the short screws for
flush bottom cabinets or the long screws for recessed
bottom cabinets. Insert two (2) screws through the
housing and into the mounting bracket. Do not tighten
the screws completely.
VISOR
SLIDES