GE ZV900SLSS - Manual (Page 6)

Installation Preparation
REMOVE THE PACKAGING
CAUTION:
LIFT THE HOOD OUT OF THE BOX
BY THE CENTER METAL PORTION. DO NOT LIFT BY THE
GLASS SIDES.
PRUDENCE :
LEVEZ LA HOTTE À
L’EXTÉRIEUR DE LA BOÎTE PAR LA PORTION MÉTAL
CENTRAL. NE LEVEZ PAS PAR LES CÔTÉS DE VERRE.
CAUTION:
Wear gloves to protect against
sharp edges.
PRUDENCE :
Portez des gants pour éviter
les blessures causées par les tranchants.
• Grasp the hood by the metal insert in the center
and lift straight up and out of the box.
• Remove and properly discard the plastic wrapping.
• Remove parts box, duct covers and other
packaging.
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED )
“ Tape measure
“ Knife
“ Spirit level
“ Wire cutter/stripper
“ Wire nuts
“ Electric drill with 5/16" and 3/8" bits
“ Phillips and flat blade screwdrivers
“ Hammer
“ Pliers
“ Safety glasses
“ Duct tape
“ Tape to mount template
“ Gloves to protect against sharp edges
“ 120V 60Hz. 15 or 20 Amp, 2 wire with
ground Properly grounded branch circuit
“ Strain relief for junction cover
“ 8" round metal duct, length to suit
installation
“ Saw, jig saw or reciprocating saw
Measuring tape
Electric drill
with 5/16”
and 3/8” Bits
12” long
Phillips
head
screwdriver
Safety glasses
Gloves
Spirit level
Knife
Wire cutter/
stripper
Flat blade
screwdriver
Hammer
Pliers
Duct tape
Masking tape
Wire nuts
Strain relief
Saw, jig saw or
reciprocating
saw
6
8" round metal
duct, length to suit
installation