GE ZIFS240PSS User Manual

Product clearances

Advertising
background image

Specification Created 3/04

120032

ZIFI240PII – GE Monogram Fresh-Food Refrigerator Module

(Custom panel required)

ZIFS240PSS – GE Monogram Fresh-Food Refrigerator Module

(Stainless steel)

For answers to your Monogram,

®

GE Profile

or

GE

®

appliance questions, visit our website at

GEAppliances.com or call GE Answer Center

®

service, 800.626.2000.

R

Listed by

Underwriters

Laboratories

Dimensions and Specifications (in inches)
Installation Space

The cutout depth must be 24"
The cutout dimensions shown allow for a full door swing and access

to the pull-out racks when installed as a built-in.
• The Fresh-Food Refrigerator can be free-standing.
• The stainless steel model ZIFS240PSS can be installed flush with

standard cabinetry. ZIFI240PII with custom panel will project

forward 1-3/4" of adjacent 24" deep base cabinets.

Note: Door swing is not reversible.

Additional Specifications:
• A 120 volt 60Hz., 15 or 20 amp power supply is required. An

individual property grounded branch circuit or circuit breaker is

recommended. Install a properly grounded 3-prong electrical

receptacle recessed into the back wall as shown. Electrical

must be located on rear wall as shown. Note: GFI (ground fault

interrupter) is not recommended.

34-1/2"-35"

24" Min.

23-3/4"

34-1/2"

23-3/4" Stainless Steel

Models

24-7/8" Framed Models

1-1/2"

Locate Outlet

9"

Max.

10-1/2"

Depth Including

Handle:

26" Stainless Steel

Models Only

23-3/4" Min.

Note: If installing between frameless

cabinets, a 1/2" wide filler strip or side panel

may be required. The filler strip will act as a

spacer between the door case and adjacent cabinet

and will prevent interference with cabinet door swing.

The width of the opening must include filler panels.

Product Clearances

16" Minimum

110˚

Wall

24"

Cabinet

14" Minimum

110˚

Wall

24"

Cabinet

All models are factory set for a 110° door swing.
For a minimum 90° door swing:
• Allow 4" min. clearance to wall on the hinge side for Stainless

Steel models.

• Allow 4-1/2" min. clearance to wall on the hinge side for models

with a custom panel and custom handle.

For a full 110° door swing:
• Allow 14" min. clearance to wall on the hinge side for Stainless

Steel models.

• Allow 16" min. clearance to wall on the hinge side for models with

a custom panel and custom handle.

Stainless Steel

Models

Models with a Custom

Door Panel

Advertising
This manual is related to the following products: