Alliance Laundry Systems UVN255P - Manual (Page 33)

Cod. G522433
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 00/0510
Tilt system assembly
33
5. ASSEMBLY INSTRUCTIONS FOR THE TILT SYSTEM ACCESSORIES
DANGER!
To assemble the TILT SYSTEM elements, machine must be moved. Take special care as this
machine's weight and volume is considerable.
5.1. Parts of the tilt system assembly
DESCRIPTION
QUANTITY
Hinge assembly to the frame base (figure 31)
Tilt hinge.....................................................................................................................4
Screw M14x55.......................................................................................................... 16
Self-blocking nuts M14 ............................................................................................. 16
ø 15 Washers ........................................................................................................... 32
Levelling supplement .................................................................................................. 6
Hold down base assembly (figure 32)
Hold down base.......................................................................................................... 2
Hold down base.......................................................................................................... 2
ø 16 mm Metallic stud............................................................................................... 12
ø 13 x 34 Washers ................................................................................................... 12
Beam assembly to the frame (figures 33/34)
Pneumatic actuator, fixing plates, beams set.............................................................. 2
M14x130 screw .......................................................................................................... 8
M14 Self-blocking nuts ............................................................................................... 8
ø 15 Washers ........................................................................................................... 16
Tilt system guards (figure 35)
Front guard ................................................................................................................. 1
Rear guard ................................................................................................................. 1
Side fixing ................................................................................................................... 2
5.2. Tools to assemble the tilt system
To assemble the tilt supplement accessories, a part from the tools indicated in section 1.2, the following tools
are required:
flat spanner 7/8 inch (22 mm)
offset ring wrench 7/8 inch (22mm)
drill for base holding down: diam. 59 inch (17mm)