Step 5, connect power, Step 6, slide product into cutout, Step 7, set temperature controls – GE ZIBS240PSS User Manual

Page 10: Caution, Attention, Installation instructions, Step 6 slide product into the cutout, Step 5 connect power, Step 7 set temperature controls

Advertising
background image

STEP 6 SLIDE PRODUCT INTO

THE CUTOUT

CAUTION:

Do not push against the door

panel with your knees. Do not push or lift the unit by
the door handle. Damage may occur!

ATTENTION :

Ne poussez jamais

le panneau de la porte avec vos genoux. Ne poussez
jamais votre appareil ou ne le soulevez jamais par
la poignée de porte. Vous pouvez l’endommager.
• Open the door and gently push the unit back into

the opening with your hands against the sides.
Be careful not to entangle power cord.

• In a standard 24" opening, the front face of

the stainless steel door will be flush with adjacent
cabinetry. A custom panel door may protrude
1-3/4" beyond the surrounding cabinets.

• Check again to be sure the unit is level.
• If the unit is installed under a countertop, adjust

the leveling legs until the unit is resting firmly against
the underside of the countertop.

• If alignment with adjacent cabinetry is an issue,

use a shim to secure the unit against the underside
of the countertop.

STEP 5 CONNECT POWER

• Connect power cord plug to a properly grounded

receptacle.

• Check to make sure power is on by opening the door

to see if interior light turns on.

• Bar Refrigerator with Icemaker – The interior fan runs

all the time except during defrost cycle when the door
is open.

• Fresh-Food Refrigerator – The interior fan runs

all the time except when the door is open.

See the Owner’s Manual for further explanation of the fan.

STEP 7 SET TEMPERATURE

CONTROLS

• The temperature controls are preset. Refer to

the Owner’s Manual for more information. Allow
12–24 hours for the temperature to stabilize.

NOTE: The Fresh-Food Refrigerator or Bar Refrigerator with
Icemaker operate very quietly. You may not notice the unit
running, and when first installed, the fans and motor may
not come on immediately – this is normal. If the display is
lit and the light is working, the unit is operating.

Installation Instructions

10

Advertising
This manual is related to the following products: