GE ZIBS240PSS - Manual (Page 8)

STEP 2 INSTALL CUSTOM 3/4"
DOOR PANEL AND HANDLE
(ZIFI240 and ZIBI240 models only)
3/4" Overlay Panel Dimensions
Model ZIFI240 and ZIBI240 require
a field-installed overlay door panel.
• The overlay panel must be
secured to a 1/4" thick backer
panel that slides into the trim.
A .10" thick spacer panel must
be placed between the overlay
and backer panel.
• A custom handle of your choice,
supplied by your cabinetmaker,
must be installed on this overlay panel. Countersink all
screws into the backer panel. Screws cannot protrude
from the backer panel.
IMPORTANT NOTE: Maximum total weight for custom
door panel is 25 pounds.
1/4"
Backer
Panel
Door
.10 Inch
Spacer
Overlay
Panel
A
B
Spacer Panel
Backer Panel
Overlay Panel
8
STEP 2 INSTALL CUSTOM 3/4" DOOR
PANEL AND HANDLE (CONT.)
(ZIFI240 and ZIBI240 models only)
Assemble overlay panels
with glue and screws.
• Center spacer panel on the
backer panel, left to right and
top to bottom. Secure the
panels with glue.
• Center the spacer/backer
panel on the overlay panel.
Secure with glue and screws. Countersink all screws
into the backer panel.
Custom Panel Hinge Routing Dimensions
Use a 3/4" router bit to cut a notch into the back side of
the assembled panel 3/8" toward the front of the overlay
panel, 3/4" deep and 7/8" wide.
Install custom door panel and handle:
• Open door to 90°.
• Remove 5 screws holding trim; lift off trim.
Retain screws.
STEP 1 REMOVE PACKAGING
AND INSTALLATION PARTS
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
• Remove the toekick attached to the back of the unit.
• Remove the custom panel attached to the front of
the unit.
CAUTION:
Small objects are a choke
hazard for children. Remove and discard any parts
not used.
ATTENTION :
Les petits objets
peuvent étrangler les enfants. Il faut jeter toutes
les pièces qui ne sont pas utilisées.
3/4" Overlay Panel Dimensions (in inches)
A (Width) B (Height)
1/4" Backer 23-3/16" 29-9/16"
0.10" Spacer 22-1/2" 29-1/16"
3/4" Overlay 23-5/8" 30"
Installation Instructions
NOTE: Right-hand models
illustrated. Follow the
same instructions on the
opposite side for left-hand
fresh food door swing
models ZIFI240 and
ZIFS240.
3/8"
7/8"
3/4"
Back side
of custom
panel
3/4"
7/8" 3/8"
NOTE: Right-hand models
illustrated. Cut notches on the
opposite side for left-hand fresh
food door swing models
ZIFI240 and ZIFS240.