GE ZIBS240PSS - Manual (Page 9)

STEP 3 LEVEL
• Use an adjustable wrench
to turn the leveling legs and
raise or lower the product.
For built-in installation, adjust
the leveling legs slightly below
the bottom of the countertop.
INSTALLATION TIP:
Measure floor to underside
of countertop inside the
opening. If the room floor
is higher than the opening
floor, adjust the rear
leveling legs approximately
1/8" less than the opening height. Screw front legs all
the way in to shorten the height at the front. This will
allow you to slightly tip the unit into the opening. Once
in the correct position, the front legs can be adjusted to
level the product.
Turn Right to Lower
Turn Left to Raise
STEP 4 CONNECT WATER SUPPLY
(ZIBI240 and ZIBS240 models only)
• Locate and bring the water line tubing to the rear
of the cabinet.
• Turn the water on to flush debris from the line.
Run about a quart of water through the tubing
into a bucket, then shut off the water.
Copper Tubing:
• Slip a 1/4" nut and ferrule over both ends of the copper
tubing. Insert the tube into the refrigerator connection
on the unit and tighten the nut.
• Turn on the water to check for leaks.
GE SmartConnect ™ Tubing:
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression nut
until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Coil excess tubing length behind the unit.
STEP 2 INSTALL CUSTOM 3/4" DOOR
PANEL AND HANDLE (CONT.)
(ZIFI240 and ZIBI240 models only)
Install custom door panel and handle (cont.):
• A custom handle of your choice, supplied by your
cabinetmaker, must be installed onto the overlay panel
before the panels are slid into the trim. Countersink all
screws into the backer panel. Screws cannot protrude
from the backer panel.
• Slide overlay panel into the door trim.
• Reinstall the side trim using the trim screws removed
earlier.
• Place the brushed decorative cover over the side trim
to hide the screw heads. Ensure side trim is aligned top
to bottom and front to back. Snap into place.
Handle
Custom
Door Panels
Screws Must
Be Countersunk
Into Panel
9
NOTE:
For shipping
purposes, the
brushed decorative
cover will be
secured to
the front of
the unit.
SmartConnect ™ Tubing
Refrigerator
Connection
1/4"
Compression
Nut
Ferrule
(sleeve)
1/4" Tubing
Installation Instructions