GE ZIRS360NXLH User Manual
Page 2
monogram.com
99
Fu
lly i
n
te
g
ra
te
d
re
fr
ig
era
to
rs
/
w
ine
r
ese
rv
e
B
u
il
t-
in
si
d
e
-b
y-
si
d
e
re
fr
ig
e
ra
to
rs
B
uil
t-
in
b
ot
to
m
-f
re
e
ze
r
re
fr
ig
e
ra
to
rs
Fre
e
-s
tan
d
in
g
re
fr
ig
era
to
rs
B
u
ilt
-i
n
a
ll
-r
e
fr
ig
e
ra
to
rs
an
d
al
l-
fre
e
ze
rs
36" Frame to
Frame Width
*84" From
Floor to
Top Frame
35"
Case Width
*83-1/2"
at
Rear
25-3/8" Framed Models
Case Depth
Depth Including Handles:
26-7/8" Framed Models
The installation space
The finished cutout width must be 35-1/2".
36" Frame to
Frame Width
*84" From
Floor to
Top Frame
35"
Case Width
*83-1/2"
at
Rear
25-3/4" Stainless Steel Models
Case Depth
Depth Including Handles:
27-3/4" Stainless Steel Models
28-11/16" Professional Models
Electrical
A 115V, 60Hz., 15- or 20-amp power supply is required. An
individual properly grounded branch circuit or circuit breaker
is recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall. Electrical
must be located on rear wall as shown.
The serial plate is located inside the refrigerator/freezer below
the bottom storage drawer on the right side.
Note: GFI (ground fault interrupter) is not recommended.
Water line
The water line can enter the opening through the floor or
back wall. Route GE SmartConnect
™
kit or 1/4" O.D. copper
tubing between the cold water line and the water connection
location at the front of the freezer. The installation of an easily
accessible shut-off valve in the water line is required.
Order GE water filter replacement cartridge, MWF. Fits all
Monogram built-in all-freezers.
Door swing clearances
The installation must allow for clearances to adjacent walls
or cabinets. These units are equipped with a 2-position door
stop. The factory-set 130° door swing can be adjusted to 90°
if clearance is restricted.
Observe all minimum clearances shown. A 90° door swing
allows pan access, but removal is restricted.
4" minimum clearance is required when the door swing
is adjusted to 90°. Allow 5" minimum clearance for
Professional models.
605Dia20
25"
Min. to
Wall
130
°
130
° Door Swing
23-7/8"
Behind
Frame
36-3/4"
605Dia21
90
°
90
° Door Swing
4" Min. to Wall
5" Min. for Professional Models
Advance planning for built-in all-refrigerators and all-freezers
*Shipping height. The product can be adjusted to fit into a cutout that is 83-1/2" min. to 84-1/2"
max. height. Note that the top case trim at the front is 1/2" higher and will overlap upper
cabinetry or soffit. Use leveling legs and wheels for a maximum 1" height adjustment.
Product dimensions