GE ZDIS150ZSS - Manual (Page 10)

Care and Cleaning
Ice maker
Cleaning
cycle
For best performance, perform a cleaning cycle
every six months. Nickel Safe Ice Machine Cleaner
by Nu Calgon is available at appliance repair
shops, or through GE Parts and Accessories. Order
part number WX08X42870. In the U.S.A., call
1.800.626.2002 or visit GEApplianceParts.com. In
Canada, call 1.800.561.3344. To clean ice maker
system, follow these instructions.
1. Turn ice production off. Remove all ice from
storage bin.
 To improve accessibility, remove cutter grid
cover by pulling bottom of cover down and
then forward.
3. Unscrew the drain cap from the bottom of the
water reservoir. Drain all water in reservoir.
4. Replace the drain cap securely.
NOTE: If the cap is not securely tightened, water
can leak, causing thin ice or no ice.
5. Pour the entire 16 oz. bottle of Nickel Safe Ice
Machine Cleaner into water reservoir. Follow all
safety precautions on the bottle. Fill the bottle
twice with tap water and pour it into the water
reservoir.
6. Replace the cutter grid cover. Insert the top
tabs first, and then push toward cutter grid to
snap into place.
7. Touch the &/($1 button. The &/($1 LED will
illuminate and the cleaning cycle will begin. If
Invalid Tone plays, press the ON/OFF button
to turn the ice maker off and try again. If "ADD
CLEANER" illuminates, see previous steps.
8. When the cycle is complete the &/($1 LED will
turn off, the Cycle Complete tone will sound,
and the “CLEANING DONE” text will illuminate.
9. After the cleaning cycle is complete, remove the
drain cap from the water reservoir to see if any
of the green cleaning solution is left in the water
reservoir. If cleaning solution drains from the
water reservoir, you should run the clean cycle
again adding only tap water to the reservoir.
Be sure to replace the drain cap before running
the cycle again.
NOTE: Severe scale buildup may require repeated
cleaning with a fresh quantity of cleaning solution.
10.Press the ON/OFF button to resume ice
production. Discard the first batch of ice.
NOTE: To stop the cleaning cycle prematurely,
press ON/OFF. The &/($1 LED will turn off and
you will hear the Power Off tone. If power is lost
before cycle is complete, cleaning will continue
when the ice maker powers on.
CLEAN
CLEANING DONE
CLEANING NEEDED
ADD CLEANER
TURN UNIT OFF BEFORE CLEANING
SEE USE AND CARE MANUAL
10
Water
reservoir
Drain
cap
Cutter
grid
cover