AT&T Trimline 265 - Manual (Page 27)

24
Storing Numbers in Memory
1. Lift the handset.
2. Press and release PROG.
3. Dial the telephone number (up to
32 digits) or press
PAUSE /REDIAL to store the
last number dialed from this
telephone.
4. For one-touch dialing, press and
release the memory button
where the number is to be stored
(M1, M2, or M3). For two-touch
dialing, press MEMORY, then
press the number button (0-9)
where the number is to be stored.
TELEPHONE MEMORY
This telephone can store 13 telephone numbers, each up to 32 digits. Dial the numbers
stored in memory by pressing one or two buttons.
Storing a CID Call Record into
Memory
1. Lift the handset.
2. Press S or T to display the call
record to be stored in memory.
3. Press PROG.
4. Go to step 4 above under Storing
Numbers in Memory.
NOTES:
If you pause for over 10 seconds
when programming an entry, the
procedure will time-out and you
will have to begin again.
If you have difficulty storing
numbers in memory, please see
Difficulty storing numbers in
memory on page 31.
Each 3.6 second pause counts as
one digit when storing numbers in
telephone memory.
Storing a Pause in a
Memory Number
Press and release
PAUSE/ REDIAL
once to store a 3.6
second pause in the
dialing sequence, twice
for a 7.2 second delay,
three times for a 10.8
second delay.