Brewer Basic 4000/4001 - Manual (Page 12)

Document #100087 RevC 12 Printed in USA © 2010
Drawer Warmer - Model 4001 Only
(Figure 11)
CAUTION
The drawer warmer may not be touched when
reaching in the top drawer. The metal surface
above the drawer may be hot. Do not let contents
of the top drawer exceed the top of the drawer;
contents packed above the drawer top could be
damaged by the drawer warmer.
The drawer warmer heats the contents of the top drawer
on the foot end of the table to approximately body tem-
perature.
To operate the warmer, turn the warmer power switch to
the ON or “illuminated” position. The switch will illuminate
to indicate that the warmer is operating.
To turn the warmer off, turn the warmer power switch to
the OFF or “non-illuminated” position. The switch will stop
illuminating, indicating that the warmer is no longer ON.
Figure 11. Operation of the Pelvic Tilt Support Bar
OPERATION (CONTINUED)
Pelvic Lift - Model 4001 Only (Figure 11)
Raising the seat section to the Pelvic Lift Position:
1. Raise the front edge of the seat section.
2. Rotate the pelvic tilt support bar upward to its full
upright position.
3. Lower the seat section onto the pelvic tilt support bar.
Lowering the seat section back to the Normal Position:
1. Slightly raise the front edge of the seat section.
2. Rotate the pelvic tilt support bar downward and lower
the seat section into its prone position.
WARNING
Do Not use drawer warmer with supplies packaged
in plastic.
Seat Section
Pelvic Tilt Bar
Drawer Warmer
On/Off Switch
Pelvic Tilt