Brewer Basic 4000/4001 - Manual (Page 6)

Document #100087 RevC 6 Printed in USA © 2010
Leveling the Table (Figure 4)
A leveling screw pad is located at each corner under the
table’s base. Adjust the four leveling pads, by turning
them up or down, to achieve a solid, level installation.
Installing the Paper Rod (Figure 5)
A dowel rod for supporting a paper roll is shipped with
each table.
1. Slide the dowel rod through the paper roll.
2. Place one end of the dowel rod on one of the paper
roll brackets, located on the rear side of the table’s
back section.
3. Slide the unattached side of the dowel rod over the
top of the other paper roll bracket.
4. Ensure a secure fit before using paper roll dispenser. Figure 4. Leveling Screw Pad (located under table)
INSTALLATION (CONTINUED)
Leveling Screw Pad
Dowel Rod
Paper Roll Bracket
Paper Roll Bracket
Figure 5. Paper Roll Installation