American Fibertek RR-94882SL - Manual (Page 7)

7
RR-94882SL
VIDEO INPUT / OUTPUT CONNECTIONS
Video input and output connections are located on the rear of the 980 series units. A BNC
connector is provided for each channel. The video inputs are connected to an appropriate 75
Ω
baseband video source such as a camera or a video recorder output. The 75
Ω video outputs
can be looped through typical baseband video inputs of switchers, recorders and other
equipment as required. For proper operation, the outputs must be terminated with 75
Ω. For
optimum performance the video cables should be the shortest length of coax practical.
The location of a video input to the RT-94882SL will be mirrored as a video output at the RR-
94882SL. For example, the Channel 2 video input on the RT-980-1550 will become the Channel
2 video output on the RR-980-1550 after traveling across the fiber infrastructure.
RT-94882SL DATA INPUT / OUTPUT CONNECTIONS
Data input and output connections are made via terminal blocks on the back of the RT-482-
1470/1490 unit. See the drawings below for proper orientation of the input and output
connections for each of the two data channels. Please note that the far right pin on each
connection drawing corresponds with the far right terminal block pin on the unit.
RR-94882SL DATA INPUT / OUTPUT CONNECTIONS
Data input and output connections are made via terminal blocks on the back of the RR-482-
1470/1490 unit. See the drawings on the next page for proper orientation of the input and output
connections for each of the two data channels. Please note that the far right pin on each
connection drawing corresponds with the far right terminal block pin on the unit.