BEABA Care thermometers Exacto - Manual (Page 21)

40 39
GB
5 . Informations on the display
Display Signification
Displays alternatively
time and room tempe-
rature when the
thermometer is not
measuring.
is displayed during 1
sec. when the thermo-
meter is turn on
Display of last measu-
rement
the battery is running
down
the battery is down
the temperature is too
high
the temperature is too
low
Room temperature is
too low or too high
Solution
Set up time before first
use and after each
battery changing.
wait until last measu-
rement is displayed
the thermometer is
ready to take a mea-
surement
you can still take mea-
surement but do not
forget to replace the
battery as soon as
possible
you must replace the
battery before taking a
measurement
the measured tempe-
rature is higher than
42,9°C
the measured tempe-
rature is lower than
32°C
Appears when room
temperature exceeds
optimal environmental
temperature for using
The first time you use the thermometer or when you change the
battery, you can, if you wish, set the clock.
Setting the clock
• Open the battery housing
• Press the black button once: the hours will flash
(2a)
• Set the hours using the button on the front face
of the thermometer
• Press the black button once: the minutes will
flash (2b)
• Set the minutes using the button on the front
face of the thermometer
• Press the black button once to end the time-set
operation (2c).
If you do not set the clock, this does not prevent the
thermometer from operating.
Only the Clock / Ambient T° functions will not be available.
Displays
There are two display modes:
• Mode Clock / Ambient T°
(figure 3)
The screen alternately displays the
time and the ambient temperature.
This mode is only available if the
clock has been set.
If not, at the end of each reading, the thermometer will display
the measured T° for 30 seconds, then “OFF” before switching
off.
6. Clock / Ambient Temperature
Figure 3
Figure 2
a
b
c