AT&T 8403 - Manual (Page 16)

16 Issue 1 March 1996
To access a feature assigned to the Feature Directory, press , and then
press the corresponding dial keypad number, through , , or . For
example, if the Send All Calls feature is assigned to Feature Directory entry F1,
you must press
, and then press to use this feature. If you have
programmed your home telephone number on an Abbreviated Dialing button
assigned to Feature Directory entry F*, you must press
, and then press
to call home.
The red lamp next to goes on when the button is pressed to let you
know that your dial keypad is now in the feature selection mode.
Hold 0
The Hold feature allows you to put your current call on hold while you answer
another call, make a call, or perform some other task.
To place a call on hold, do the following:
1. Press .
■ The current call is placed on hold and the green status lamp at the
call appearance flutters.
To place a call on hold and answer a new call, do the following:
1. Press .
■ The current call is placed on hold, and the green status lamp at
the call appearance flutters.
2. Press the call appearance button of the incoming call.
■ You are connected to the incoming call.
To return to a held call, do the following:
1. Press the call appearance button of the held call.
■ You are reconnected to the held call.
Feature
0 9 * #
Feature 1
Feature
*
Feature
Hold
Hold