ADTRAN L768 - Manual (Page 67)

Chapter 3: Terminal Menu Operation and Structure
61202192L1-1 Express L768/L1.5 User Manual 51
IP Map/IARP
Write security: 3, Read security: 5
When this is set to Yes (def), the Express L768/L1.5 will send Inverse ARP
packets in order to determine the IP address on the other end of the virtual cir-
cuit. If the IARP is responded to, a route is placed in the IP route table. A set-
ting of No means that the route address is to be assigned statically using the
IP Map/Far-End IP Address
parameter. The Express L768/L1.5 will always
respond to Inverse ARP requests.
IP Map/Far-End IP Address
Write security: 3, Read security: 5
This is the IP address of the device on the other end of the virtual circuit.
When this DLCI becomes active, the Express L768/L1.5 will add a route in the
IP routing table.
IP Map/IP Netmask
Write security: 3, Read security: 5
The IP network mask to apply to the Far-End IP Address and Link IP Address
is specified here.
IP Map/Link IP Address
Write security: 3, Read security: 5
The virtual circuit may require an IP address to be specified at this DLCI inter-
face. This is called a numbered interface. This address is used by the Express
L768/L1.5 to respond to Inverse ARP requests. If this IP address is left as
0.0.0.0, the link is treated as unnumbered and the Express L768/L1.5 responds
to the Inverse ARP with its Ethernet IP address.
IP Map/RIP Protocol
Write security: 3, Read security: 5
The RIP protocol can be specified per DLCI. The possible selections are Off
(meaning no RIP packets are listened to or sent), V1 (def) (which is RIP version
1) or V2 (which is RIP version 2).