Boonton 4500B Peak Power Meter - Manual (Page 298)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-98
Table 5-1. SCPI COMMAND SUMMARY
*OPT
Return the instrument options
*CLS
Clear Status Command
*ESE
Set/get Standard Event Status Enable
*ESR?
Standard Event Status Register Query
*IDN
Identification Query
*OPC?
Operation Complete Query
*OPC
Operation Complete Command
*RST
Reset Command
*SRE
Set/get Service Request Enable
*STB?
Read Status Byte Query
*TRG
Simulate GET
*TST?
Self-Test Query
ABORt
Immediately set measurement trigger system to idle
CALCulate:AMEAsure:BOTtom
Set/return state of IEEE automatic bottom detection. <arg> = ON, OFF
CALCulate:AMEAsure:EDGEdelay
Set/return edge delay mode. <arg> = FRST, LAST, BRST
CALCulate:AMEAsure:MODE
Set/return argument A. <arg> = ALL, FRST, MRKRS, OFF
CALCulate:MATH:ARGA
Set/return argument A. <arg> = CH1, CH2, TRIG1, TRIG2, MEM1, MEM2
CALCulate:MATH:ARGB
Set/return argument B. <arg> = CH1, CH2, TRIG1, TRIG2, MEM1,MEM2
CALCulate:MATH:OPERator
Set/return operator. <arg> = CH_SUM, CH_DIF, CH_RAT
CALCulate:MODE
Set/return instrument mode. <arg> = PULSE, MODULATED, STATISTICAL
CALCulate[1|2|3|4]:PKHLD
Set/return state of the peak hold function. <arg> = OFF, ON
CALCulate[1|2|3|4|5|6|7]:STATe
Enable currently selected channel allowing measurements to be made.
<arg> = ON, OFF
CALCulate:SYSTRK
Set/return state of system tracking. <arg> = ON, OFF