Clinton Electronics CE-20PVMDVR User Manual - Manual (Page 11)

11
Access to the Camera and OSD Board
The access door to the camera and OSD Board is located
at the bottom of the 20” unit, and back of the 8” unit. A
Phillips screwdriver is required to remove the access
panel screw from the 20’ unit (Fig. A), place the screw in a
location where it will not be lost. The access panel for the
8” unit can be finger loosened (Fig A2).
The OSD board is attached to the access panel for easy
adjustment of the parameters of the camera while
viewing the front of the screen (Fig. B).
The Zoom and Focus on the 20” unit can be adjusted by
loosening the two adjustment dials on the lens (Fig. C).
When the desired Zoom and Focus settings are reached,
finger tighten the dials; do not over tighten.
LENS (Selection)
SHUTTER (Condition and Speed Control)
WHITE BALANCE (Control)
BACKLIGHT (Backlight Compensation)
AGC (Auto Gain Control)
DNR (Digital Noise Reduction)
SENS-UP (Low Illuminance)
SPECIAL
EXIT
MANUAL
ESC
ATW
OFF
OFF
OFF
OFF
CAMERA ID
SYNC
PRIVACY
SHARPNESS
RETURN DC
MANUAL
AWC
LOW
LOW
LOW
AUTO
FLK
MANUAL
MIDDLE
MIDDLE
MIDDLE
HIGH
HIGH
HIGH
SETUP MENU
OSD Menu
POWER AUTO UP DOWN MENU
SD Card
16
GB
SD Card
2
GB
Focus
Zoom
POWER AUTO UP DOWN MENU
SD Card
16
GB
SD Card
2
GB
UP
RIGHT
LEFT
DOWN
SET
B.
C.
COLOR
MOTION DETECTION
MIRROR
RESET
A. CE-20DVRPVM-HD
A2. CE-8DVRPVM-HD