Eddie Motorsports MS107-50 - Manual (Page 4)

4
Install Main Bracket:
1. Install main bracket using four M8 x 25mm cap screws and washers with anti seize.
Finger tighten.
Install Power Steering Pump with Pulley:
1. Install power steering pump using two 5/16-18 x 3” cap screws and lock washers with
anti seize. Tighten firmly.
WARNING:
Do not start the engine until power steering hoses, reservoir, fluid, etc are installed and system
is filled and bled. See the enclosed instructions for details on this procedure. Running the pump
dry will void the warranty.