EOTech Mini Red Dot Sight (MRDS) - Manual (Page 23)

2-9
d. Mount the target on an “E” silhouette or other suitable surface at 25 meters.
e. Press the MRDS pushbutton and adjust intensity of the red dot to a comfortable
level (see section 2.8).
f. Assume a good firing position and align the MRDS red dot with the center of the
target.
g. Fire a 3-round shot group and note the center of the shot group relative to the
designated strike point.
h. Rotate the boresight adjusters to move the center of the shot group to the
designated strike point.
i. Fire another 3-round shot group and observe the center of the new shot group
relative to the designated strike point.
j. When 2 out of 3 rounds are in the designated strike zone, the MRDS is aligned with
the barrel of the host weapon.
2.5.3 Zeroing at an Extended Range
. The MRDS may be zeroed for a specific point of aim /
point of impact at an extended range. This is appropriate for mission profiles where the likely
engagement range is known, or for engagement ranges in excess of 50m.
a. On a suitable target, draw a designated strike zone around the center of the target
that corresponds in size to an acceptable degree of accuracy.
b. Place the target downrange at a known distance (e.g., 100m).
c. Press the MRDS pushbutton and adjust intensity of the red dot to a comfortable
level (see section 2.8).