Equus 3660 - Hand Vacuum Pump & Brake Bleeding Kit - Manual (Page 20)

18 3660
B. FLUID EVACUATION PROCEDURES
1. Assemble the fluid evacuation/brake bleeding kit as described on
page 16.
NOTE: If a large quantity of fluid is to be evacuated, it is advised
that a larger fluid reservoir jar be used. A fluid evacuation kit that
includes a 24-ounce (720 ml) reservoir jar and longer tubing is
available as an option. See page “REPLACEMENT PARTS” on
page 20 for more information.
2. Insert the open end of the clear tubing into the item from which
fluid is going to be evacuated. (Make sure the evacuation kit is
assembled properly and the jar lid is properly tightened).
3. Squeeze and release the pump handle, as needed, until the desired
amount of fluid is evacuated.
CAUTION: To prevent fluid from being drawn into the pump
body, only evacuate fluid until the reservoir container is
half full. When the container is half full, use the relief valve
on the pump to release the vacuum, then empty the container
and repeat the procedure until the desired amount of fluid
is evacuated.
XII. BLEEDING BRAKES
WARNING: Most Anti-Lock brake systems use a high-pressure
pump to maintain system pressure. ALWAYS observe the
following precautions when servicing Anti-Lock brake systems:
• ALWAYS refer to the manufacturer's service manual for service
and repair procedures for your vehicle's Anti-Lock brake system.
• ALWAYS wear safety goggles when performing servicing
procedures.
• ALWAYS depressurize the system before adding brake fluid or
performing servicing procedures.
• ALWAYS use manufacturer-recommended brake fluids ONLY.
• Unless directed to by the manufacturer's service procedure,
NEVER open a bleeder valve or loosen a hydraulic line while the
system is pressurized.
A. BLEEDING AUTOMOBILE BRAKES
CAUTION: Brake fluid is very caustic (corrosive) and will
damage painted surfaces. Take precautions to prevent brake
fluid from contacting these surfaces. If brake fluid contacts a
painted surface, wash it off immediately.