Fantasea Line Blue Ray Double Tray - Manual (Page 5)

5
Fantasea Blue Ray Tray Instruction Manual
b. With the top of the tray and black T1 Connector facing up, hold the Ikelite camera
housing above the tray so the two mounting screw holes featured at the bottom of the
housing are aligned with the two Ikelite-housing-dedicated screw holes found on the
tray.
c. Install the two Ikelite-housing-dedicated screws included in the kit.
i. Make sure that the two washers included with this kit are installed on the
screws.
ii. Insert the screws from the bottom of the tray through the aligned screw holes
featured on the tray and housing (image #3) .
iii. Tighten the screws to ensure the housing remains within a fixed position on the
tray.
3. Installing the Blue Ray Tray Extension (optional)
Installing the optional Blue Ray Tray Extension enables mounting a second arm on the
tray, thereby integrating additional accessories in the system, such as external flashes,
lights and more.
a. Hold the tray with its bottom facing up, so the black T1 Connector is facing down.
b. Place the black spacer on the end of the tray, opposite the end which features the
black T1 Connector. When properly held and placed, the black spacer is positioned on
top of one end of the tray, while the black T1 Connector is featured at the bottom of
the other end of it
(image #4).
Image #3
Image #4