Fantasea Line Blue Ray Double Tray - Manual (Page 6)

6
Fantasea Blue Ray Tray Instruction Manual
c. Align the 4 screw holes featured at the end of the tray with those found on the black
spacer.
d. Place the blue extension on top of the spacer, so that the T1 Connector featured on
the blue extension is facing down and the 4 screw holes are aligned with the screw
holes of the black spacer. The set of 4 screw holes featured on the tray, black spacer
and extension should now be aligned
(image #5).
e. Insert the 4 screws included with the extension kit through the dedicated aligned
screw holes, starting from the extension and proceeding through the spacer and
tray.
f. Tighten the screws to complete the installation of the Blue Ray Extension.
g. Return to section #1 for instructions regarding mounting the camera housing on the
Blue Ray Tray.
4. Mounting Flex Arms on the Blue Ray Tray
a. The Flex Arm features a T1 Mount at the bottom of the arm that was designed to be
attached to the T1 Connector featured on the tray.
b. Glide the T1 Mount of the Flex Arm on the T1 Connector featured on the tray (image
#6) till they are perfectly aligned (image #7). If you encounter any resistance, slightly
loosen the screw featured on the bottom of the Flex Arm so it doesn’t get in the
way.
c. Tighten the screw featured on the T1 Mount in order to lock the arm on the tray.
d. In order to ensure that the arm is completely locked, try to push it out of the tray by
gliding the Flex Arm T1 Mount out of the T1 Connector. If the Flex Arm comes out,
repeat the steps listed above and make sure that the T1 Mount and T1 Connector
are perfectly aligned when tightening the screw.
Image #5