Fantasea Line Nano Flash Action 700 Lighting Set - Manual (Page 7)

7
Fantasea Nano Flash Instruction Manual 26110120
g. Mount the Nano Flash on an Arm
i. Remove the screw from the Y-S Connector at the bottom of the Nano Flash
Housing by unscrewing it all the way out.
ii. Position the Nano Flash on top of the arm so that the Y-S Mount on top of the
arm is aligned with the Y-S Connector at the bottom of the Nano Flash (image
#5).
iii. Install the screw all the way through the Nano Flash and arm. Tighten it
enough to keep the Nano Flash within a fixed position (image #6).
h. Attaching a Nano Fiber Optic Cable to the Nano Flash (optional)
Although the Nano Flash features a slave sensor and is capable of synchronizing
with the camera internal flash without using any cables in most diving conditions,
a fiber optic cable ensures the best synchronization between the camera internal
flash and the Nano Flash at all angles and within various diving conditions,
especially when photographing in shallow clear water with bright ambient light.
i. The fiber optic cable consists of
two ends: One is attached to a
white plastic fitting (flat white
plastic at the end of the cable
with Allen screw inside), and
the other is loose (image #7).
Insert the exposed end of the
fiber optic cable (the end
without the fitting) into the
small hole of the black Nano Adaptor unit, starting from the end that features
a screw and pushing it towards the end that features an O-ring, until the fiber
optic cable reaches the end of the adaptor.
ii. Use the tool included in the Nano Adaptor Kit in order to tighten the screw
on the adaptor (image #8 on the following page). Tighten it enough to
Image #5 Image #6
Image #7