Fantasea Line Nano Flash Action 700 Lighting Set - Manual (Page 8)

8
Fantasea Nano Flash Instruction Manual 26110120
stabilize the fiber optic cable inside the adaptor, but don't tighten it too
strongly. Tightening the screw too much might damage the fiber optic cable.
iii. Install the black and clear plastic diffuser cover on the Nano Flash Housing.
iv. Insert the Nano Adaptor inside the lower right grommet (the one with the
wider hole) of the black diffuser cover, so that the adaptor screw doesn't get
in its way. Insert it all the way to the end, and do not use force once you
encounter any resistance (image #9).
v. If attaching the Fiber Optic Cable to
a Fantasea FP7000 Housing or any
other housing that features a
dedicated fiber optic cable
attachment configuration (image
#10), please refer the housing
instruction manual for specific
instructions regarding attaching the
fiber optic cable to the camera housing. If attaching the Fiber Optic Cable to
any other standard camera housing, please follow the instructions below.
vi. The other end of the fiber optic cable attaches outside of the camera housing
- opposite the camera internal flash - by using both sides of the Velcro strip
included in the kit. The white plastic fitting normally comes with the Velcro
tape attached and therefore you are only required to apply the other side of
the Velcro strip on the housing to receive it (images #11 and #12 on the
following page). If your housing features a built-in flash diffuser, the Velcro
strip should be attached beneath it, directly to the housing. If possible, place
the Velcro strip between the built in flash diffuser and the housing,
positioned opposite the internal flash of the camera.
Image #8 Image #9
Image #10