Fantasea Line Illuma 500 Dive Light - Manual (Page 2)

2
Fantasea BlueRay Illuma Dive Light Instruction Manual 20121205
Instructions for Use
A. Installing & Removing Batteries
a. To open the BlueRay Illuma Dive Light, hold the hand grip firmly in one hand
with the hand grip pointing towards your body and the LED head pointing
away. Turn the LED head clockwise until it separates. Pull the LED head off.
Please make sure that the light is pointed in a slightly upward position so
the battery cartridge inside the light does not fall out when the light is
opened.
b. Take the battery cartridge out of the light by turning the body of the light
upside down. Make sure to grasp the battery cartridge as soon as it comes
out from the light so it doesn’t fall out.
c. Install or remove 6 x AAA batteries inside the battery cartridge. Make sure
to follow the instructions diagrams printed on the interior of the battery
cartridge. Note that there are three sets of two batteries, each set pointing
towards a different direction.
d. Install the battery cartridge back into the body of the light so that the end
with the round contacts faces the opening and towards the LED head.
e. Re-install the LED head on the opening, carefully aligning it with the thread
on the body of the light and tightening it evenly in a counterclockwise
fashion. Do not use force and do not allow it to screw down unevenly.
Tighten the LED head until the light goes on and then unscrew it clockwise a
bit, just enough for the light to turn off. Once the light is turned off, do not
continue turning the LED head, or else the watertight seal of the light may
be affected and possible flooding may result.
f. Take special care not to stare into the light beam or shine it into the eyes of
anyone else, because the light is powerful and could damage ones’ eyes.
g. It is recommended to occasionally apply a slight amount of silicone grease to
the black O-ring seal found below the threads of the body of the light prior
to replacing the LED head.
B. Turning the BlueRay Illuma Dive Light On/Off
a. In order to switch the light on, hold the hand grip firmly in one hand with
the hand grip pointing towards your body and the LED head pointing away.
Carefully turn the LED head counterclockwise all the way to the end.
b. In order to switch the light back off, turn the LED head in a clockwise fashion
just enough for the light to turn off.