Fantasea Line Illuma 500 Dive Light - Manual (Page 3)

3
Fantasea BlueRay Illuma Dive Light Instruction Manual 20121205
c. Once the light is turned off, do not continue turning the LED head, or else
the watertight seal of the light may be affected and possible flooding may
result.
d. Please note: If you are turning the LED head more than half a turn and
nothing happens, you are probably turning it the wrong way.
e. Note that the BlueRay Illuma Dive Light features two power output levels:
100% and 40%. In order to switch between the two power output levels,
once the light is turned on, turn the LED head clockwise just enough for the
light to turn off and then turn it counterclockwise until it turns on again.
Each time the light is turned off and on again alters the output level.
C. Mounting the BlueRay Illuma Dive Light on an Arm
a. An optional BlueRay YS Mount A (Cat. No. 4028) enables mounting the
BlueRay Illuma Dive Light on any arm or connector that features a standard
YS Mount at the top, such as on Fantasea Flex Arms.
b. In order to install the BlueRay YS Mount A on the BlueRay Illuma Dive Light,
first apply a slight amount of silicone grease on the two O-rings featured on
the interior of the YS Mount without removing them. This will allow for a
smoother installation.
c. Remove the hand lanyard from the light.
d. Install the YS Mount by sliding it on the body of the light, starting from its
rear end and all the way towards the LED head, till it reaches a widening and
can no longer be slid forward.
e. Re-install the hand lanyard back on the light.
f. Remove the screw from the bottom of the YS Mount by unscrewing it all the
way out.
g. Position the BlueRay Illuma Dive Light over the arm so that the YS Mount on
top of the arm is aligned with the YS Mount at the bottom of the LED light.
h. Install the screw all the way through the YS Mount and arm connectors.
Tighten it enough to keep the LED light in a fixed position.
D. Care & Maintenance
a. After each dive, carefully soak and rinse exterior components in fresh water.
b. Store the BlueRay Illuma Dive Light in a protected, dry and shaded area.
c. Remove batteries when storing the LED light for an extended period of time.
d. Please note that there is never a need to use force when closing or opening
the light or when turning it on or off.