MBRP S5082 - Manual (Page 2)

S5082 © 09/13 PAGE 2 OF 4
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Remove the clamp after the catalytic converter and save the clamp
for the installation. Refer to Figure 1.
3. Remove the hangers from the rubber insulators and remove the
exhaust from the vehicle. The tail pipe can be cut to ease clearing the
rear axle. Refer to Figure 2.
4. Remove the exhaust from the vehicle.
Installation of MBRP Inc. Performance Exhaust
1. Install the Extension Pipe to the existing flange using the clamp
removed earlier. Leave the hardware loose enough for some adjustment.
Refer to Figure 3. The Extension Pipe will not need cutting for the Crew
Cab short bed or the Extended Cab long bed. Refer to Figure 4 for cut
lengths. (Installation tip: Temporarily hang the Muffler and the Over
Axle Tail Pipe in place and measure to the back of the Catalytic Converter
to verify the length required).
Figure 1
Figure 2
Figure 3
Figure 5
Figure 4